2009-12-03
MACH8 Slim Lite 2.5 Serial ATA Solid State Drive
The MACH8 Slim Lite 2.5 Serial ATA (SATA) Solid State Drive (SSD) is a non-volatile mass storage device and is intended as a replacement for a SATA-compliant hard disk drive (HDD). The drive can be configured as a boot or data storage device. The drive is Plug and Play (PnP) compatible; no additional device drivers are required to install the drive. The SSD is recognized by PnP-compatible operating systems and PnP-aware BIOS.
The SSD can be installed in any system that supports SATA 1.0 or greater devices; the drive is compliant with SATA 2 standards and supports all ATA and ATAPI devices. The SSD has a fully compliant ATA/ATAPI-8 Serial ATA interface, a 22-pin (7-signal, 15-power) connector, and conforms to the same mechanical and mounting requirements as a standard rotating disk drive.
The SSD is available in unformatted memory capacities of 8, 16, 32 and 64 gigabytes. The memory is comprised of Single-Level Cell (SLC) or Multi-Level Cell (MLC) NAND EEPROM flash components.
The drive can operate as sustained read/write transfer rates of up to 90 megabytes per second. Power consumption is kept to a minimum; the SSD can be powered from a 5-volt source or an alternative 3.3-volt source. The solid state design eliminates electromechanical noise and delay inherent in traditional magnetic rotating media. The wear-leveling and bad-block mapping algorithms ensure data integrity.
Your contact:
