EM1206EV Evaluation Board

The EM1206 is a miniature BASIC-programmable embedded module. In combination with the RJ203 jack/magnetics, the EM1206 occupies only 34.5x19 mm of board space. Alternatively, the EM1206 can be used with any suitable magnetics and jack.
The modules hardware mix, which includes 100Base/T Ethernet, four serial ports, flash disk, EEPROM, and RTC, has been carefully tailored to address the typical needs of network-enabled control applications.
This makes the EM1206 especially suitable for connected edge products such as sensors, network-enabled card readers, actuators, and other lightweight devices.
The EM1206 can also support Wi-Fi communications (this requires GA1000 add-on board), as well as external LCD, keypad, and buzzer.
The EM1206 can be ordered standalone or in combination with the RJ203 module.

Specifications:

*Based on a high-performance purpose-built 88-MHz ASIC (T1000)
*10/100BaseT auto-MDIX Ethernet port (no magnetics)
*Optional Wi-Fi interface (requires GA1000 add-on module)
*Four high-speed serial ports (CMOS-level):
-Baudrates of up to 921,600bps;
-None/even/odd/mark/space parity modes;
-7/8 bits/character modes;
-Full-duplex mode with optional flow control;
-Half-duplex mode with direction control;
-Encoding and decoding of Wiegand and clock/data streams
*Up to 1024KB flash memory for firmware, application, and data
*2KB EEPROM for data storage
*RTC with backup power input
*Supports external LCD and keypad
*Programmable square-wave output for external buzzer
*Up to 17 general-purpose I/O lines (including 8 interrupt lines)
*Control lines for two external status LEDs
*Four status LEDs onboard:
-Green and red status LEDs;
-Green and yellow Ethernet status LEDs
*Software-controlled onboard PLL
*Reliable power-on/brown-out reset circuit
*Power: 230mA @ 3.3V (100BaseT mode, PLL on)
*Dimensions: 33.2x18.1x5.5mm
*Firmware is upgradeable through the serial port or network